2.6.31.9 Kernel Update

January 7th brings us another kernel release. From the changelog:

• 2.6.31.9
• LED platform device and trigger support for ide-disk (PATA) and mmc (SD card)
• A few GPIO setup optimizations nobody will notice (including that annoying error on boot)
• Patches from Pegatron
• HDMI AV Information fix (wrong refresh rate)
• HDMI EDID support, should autodetect your panel and use a native mode
• Headphone detection fix
• Reboot workaround
• Board identification fix to differentiate between ER1 and ER2 (not shipping) boards
• Some regulator changes
• Patches from SUSE
• ext3 fixes (superblock uptodate flag fix, barriers by default, JBD timeout increased to 15 seconds)
• XFS fixes (redirty delayed allocations fix)
• NFS write bug fix
• RT3070 driver backport from 2.6.32 staging
• USB storage devices delay 1 second instead of 5 when being plugged in
• USB UVC webcam hue fix
• Slightly better HDMI mode autodetection and usage including cleaning up impossible mode.
• Enabled both the RT3070STA (Ralink/Staging) and RT2870 (Mainline) wireless drivers. Blacklist the ones that works the worst for you (rt2800usb, rt2870sta, rt3070sta)
• Disabled the Boot Logo

You can find them at the Efika MX Kernel Platform Support page. The kernel support is shipped as a set of patches - simply extract it into your kernel directory and then run patches/patch-kernel.sh to update (just like a Freescale BSP). The new configuration file will be copied to .config inside the kernel tree for convenience.

Binaries are also available.

We would much appreciate it if we could get some input on whether this fixes peoples' display problems, and if it does or does not (either way), please post in the forums a copy of your dmesg output (log serial, copy it to a file, any way you like) so we can check EDIDs and errors.

Hope you're all having a great new year.